The MicroKorg now responds to my UC-16 knobs and responds properly! I had to set the midi filter to "Enable" for control change in order for the MicroKorg to transmit and receive midi CC messages. However, MicroKorg does not respond to UC-16 knobs. So now we have midi out UC-16 to midi in MicroKorg. However, the synth does not respond to the CC on the controller knobs when I move them.īTW, after configuring the control change map in the editor and sending the settings to the MicroKorg, I did make the crucial step of unplugging the midi cable from the midi out on the interface and plugging it into the midi out on the UC-16 before trying to send CC commands from the controller. Everything in the sound editor and on the controller appears to be set up correctly as I intended it. Now, I'm trying to figure out how to get the control change map settings on the MicroKorg to respond to my external midi controller (Evolution U-Control UC-16) after setting them up in the sound editor and sending them to the MicroKorg. Note: the Sound editor does tell you to turn off write protect, but it makes no mention of changing the midi clock to external - which was the issue in my case.Same here with me.
Very old thread I know, but I was just having the same problem and Ether Trogg had the answer! Thanks!
0 kommentar(er)
